// Initialize SEP5 at address 0x50 on I2C bus 2 sep5_handle_t dev = sep5_init(SEP5_I2C, 2, 0x50);
The is typically found within the sepdk/src directory of an Intel oneAPI or VTune installation. Because it is a kernel module, it must often be recompiled when the host operating system's kernel is updated. Management Task Command Example Check Driver Status sudo ./insmod-sep -q Build & Install sudo ./build-driver -ni followed by sudo ./insmod-sep Unload Driver sudo ./rmmod-sep Automate at Boot Handled by the sep5.service systemd script Troubleshooting Common Issues sep5 driver
// Configure sensor mode sep5_config_t cfg = .mode = SEP5_MODE_CONTINUOUS, .sampling_rate = 1000, // Hz .buffer_size = 256 ; sep5_configure(dev, &cfg); // Initialize SEP5 at address 0x50 on I2C
Some key features of a SEP-5 driver include: .sampling_rate = 1000